Robot parts in stock: Heavy Duty Servo, Brackets, Drag Chain, 8mm Linear guide, bushing and fixers.

MS-9.5-55-MG is heavy duty metal gears 9.5 kg.cm servo motor 0-180 degrees for Arduino projects.

MS-DISK-20MM is aluminum disk which allow MS-9.5-55-MG servo to be connected to MS-BRACKET, MS-BRACKET-U, MS-BRACKET-W and MS-BRACKET-L and allow complex combination with different degrees of freedom.

DRAG-CHAIN-10×10 and DRAG-CHAIN-7×7 are plastic wire guide for CNC X-Y tables.

HSS-8-500MM is surface hardened Stainless Steel linear guide which is with 8 mm diameter and cut to 500 mm length. It’s essential part of every CNC project and can be used with SUPPORT-SHF8 , SUPPORT-SK8, 608ZZ , KFL08, KP08 , SC8UU bearing, BUSHING-15×12-8 and FIX-RING-8.

 

 

KiCAD 6 Donation campaign

Probably inspired by the successful Bootlin campaign for open source Allwinner VPU drivers, two days ago Maciei Suminski and Tomasz Wlostowski made Youtube video where they apeal for fund rising 30 000 CHF for the development of KiCAD v6!

Everyone can show their support for the most successful open source PCB design tool at:  https://givetokicad.web.cern.ch

Lot of Robot and CNC parts are now in stock stocked.

We needed these for our own projects development, but decided that other may need these in small quantities as well, so decided to stock:

Linear Guides,

Bearings,

Stepper Motors,

Couplers,

Shaft supports

A13 Touchscreen support for Debian

I posted for how to add Touchscreen support for Debian for A13 in December 2012, but things changed a bit since then so I got GitHub pull request from Nikita Maslov. We tested his patches and they work fine on A13 so his request was pull and merged in our GitHub account.

On top of this he made small post on his blog how to implement it, which I link here: http://www.dimrobotics.com/2013/06/olinuxino-a13-touchscreen-support-in.html

iMX233-OLinuXino is now supported officially by ARCHLINUX

Here are instructions how to install ARCH on iMX233-OLinuXino http://archlinuxarm.org/platforms/armv5/olinuxino and here is the ARCH official anouncement http://archlinuxarm.org/article/20120721/support-olinuxino-available